Fully Automatic Crimping Machines
CN308
CN308 is a fully automatic processing machine capable of performing
multiple operations in a single sequence — including wire cutting, stripping,
tube printing, tube insertion onto wires, and terminal crimping.
Each process is modularized, allowing flexible configuration changes
according to the user’s specifications and production requirements.
- Supports up to 10 types of loose terminals with a single crimping unit
- Excellent cost performance
- Handles up to 36 different wire types
- Genuine Nichifu dies (planned)
| Applications | For internal panel wiring |
|---|---|
| Wire Size | 0.3 – 5.5 mm², compatible with up to 36 types of wires |
| Functions | Wire cutting to fixed length, both-end stripping, printing on tube, tube insertion onto wire, both-end crimping. |
| Capacity | Wire cutting, tube printing and insertion, both-end crimping: About 8 sec/pc (450 pcs/hour) |
| Wire size | 0.3 – 5.5 mm², compatible with up to 36 types of wires |
| Wire cutting length | 1.0 mm + set cutting length × 0.002 |
| Stripping length | 0.1 ～ 17.0mm |
| Applicable terminals | Bare terminals, insulated terminals, ferrule terminals, continuous terminals |
| Applicable marking tubes | Round tubes |
| Crimping capacity | 30,000 N (equivalent to 3 tons), equipped with a servo crimping unit |
| Power source | Three-phase AC 220V 10A, 50/60Hz, with transformer |
| Compressed air | 0.6 MPa, 200 NL/min (please use clean, dry air) |
| Dimension | W5000mm x D2750mm x H1850mm |
